Working with HIGO molded connector cables often requires you to splice a cable, like for example when making an extension cable from 2 seperate HIGO cable connectors.
Start off by cutting the cable ends to the required length, allowing for an additional 5 mm where the wires overlap.
Here is part 1, showing you how to prepare the cable ends before you join them:
Once the preparation is done and everything is ready, it's time to get busy.
Get your crocolile clamps and solder iron ready, then start with the innermost cable:
Now that the wires are joined, the splice has to be encapsulated to make it water- and dustproof to a high degree.
To do that, cut off a few centimeters of self-welding insulation tape, and then cut this piece into smaller strips. Wrap by gently pulling the tape.
Finish your splice off by gently rolling the still warm joint over a flat surface.
Wir nutzen Cookies auf unserer Website. Einige von ihnen sind essenziell für den Betrieb der Seite, während andere uns helfen, diese Website und die Nutzererfahrung zu verbessern (Tracking Cookies). Sie können selbst entscheiden, ob Sie die Cookies zulassen möchten. Bitte beachten Sie, dass bei einer Ablehnung womöglich nicht mehr alle Funktionalitäten der Seite zur Verfügung stehen.